76423008 - Dynojet Lambda Sensor Eliminator HONDA

DYNOJET - Lambda Excluder

These components allow you to exclude or manage the lambda probe, if present, to prevent it from interfering with the action of the Power Commander. They do this by avoiding sending error signals in the original control unit, which would lead, in some cases, to the activation of the protection mode that limits the delivery of the engine.

On the latest generation motorcycles, one or more lambda probes are installed that have the function of communicating to the original control unit the amount of oxygen present in the exhaust gases. The original control unit is programmed to comply with anti-pollution regulations such that the air/gasoline ratio must be thinner than what would be optimal for the correct operation of the engine.

If you install an additional Power Commander control unit without excluding/disabling the original lambda probe it will not be possible to fully control the carburetion as the original control unit would make continuous corrections.

The Dynojet lambda probe excluder (O2 eliminator) is installed in place of the original lambda probe (one or more depending on the motorcycle model) and replaces it.

The O2 eliminator is a connector with a simple circuit that provides the original control unit with a signal so that the motorcycle control unit does not detect faults or errors. With the O2 eliminator installed it is possible to 100% control the entire gasoline map to obtain the optimal air/gasoline ratio.

Other information:

Compatible Motorcycles:

• HONDA CB 1300 (08-09)
• HONDA CBF 1000 (06-09)
• HONDA CBR 1000 RR (04-07)
• HONDA CBR 600 F (11-13)
• HONDA CBR 600 RR (07-12)
• HONDA Hornet 600 (07-13)
• HONDA Transalp 700 (08-13)
• HONDA Transalp 700 ABS (08-13)
• SUZUKI Burgman 650 (02-12)
• SUZUKI GSR 400 (06-11)
• SUZUKI GSR 600 (06-13)
• SUZUKI GSX-R 600 (06-07)
• SUZUKI GSX-R 750 (06-07)
• SUZUKI Intruder C1800R (08-08)
• SUZUKI Intruder M1800R (09-19)
• SUZUKI Intruder M1800R2 (08-08)